Bli medlem i Norsk elbilforening og støtt driften av Elbilforum. Som medlem får du i tillegg startpakke, medlemsfordeler og gode tips om elbil og lading. Du blir med i et fellesskap som jobber for mindre utslipp fra veitrafikken. Medlemskap koster 485 kroner per år. elbil.no/medlemskap

Sv: Slakke i transmisjonen - skal det være slik eller er det noe galt?

Startet av Citrus, torsdag 28. august 2014, klokken 12:57

« forrige - neste »

Citrus

Dear All,

I noticed a small amount of water has been able to end up in the storage area below the trunk cover. At the outer sides of both recesses is discolouration of the fabric visible and the moisture can be felt.

The rubber seal against the glass tailgate seems to be perfectly waterproof. I suspect the connection between the black plastic panels (where the rubber seal is mounted upon) and the (in my case yellow coloured) outer shell not being completely waterproof.

Anyone having the same issue? Of course anyone with a solution is most welcome to reply as well  ;D

Tanks in advance! Jaap.

Go-carter

Hello,

This is quite ordinary. If I remember correctly, it leaks underneath the rubber seal, because of the geometry of the plaqstic panels. I think the fix was to remove the seal, put lots of silicone/grease inside the groove, and push it back on.

Hopefully someone who remembers exactly will chime in :)
TMX60D
Leaf S 2015
Think 2011 2+2 Zebra "Sola" 106.000km pr. mars 2017
Think 2008 "CaThinka" kommende banebil

hma

Here is my recipe, it's 'på norsk', but google translate might do a propper job :)
http://elbilforum.no/forum/index.php/topic,10970.0.html
- Toyota Rav4 EV 2000 NiMH (06/2010), Tesla Model S75D (12/2018)
   (tidligere: Think Classic 2000 NiCd (06/2009-05/2012) - Think City 2010 Zebra (03/2012-10/2012) - Think City 2009 Zebra (05/2012-05/2014)  - Tesla Model S 2014 (06/2014-09/2017) - Nissan Leaf 2018 LE 40kWh (04/2018-12/2018) )
- Trondheim (Trøndelag Elbilforening 02/2012-04/2014)
- Ariens AMP 24 to-trinns snøfreser 48V litium 52,5Ahr (10/2012) - Bosch Rotaks 43 Li-Ion gressklipp

Citrus

Dear Go-carter and HMA,

Thanks for the suggestions, indeed redoing the rubber profile did the trick. I used 3M 08509 glue (remains flexible and does not harden) and needed more then 250 ml (and had to remove only a teaspoon full).

Thanks again, Jaap.


© 2024, Norsk elbilforening   |   Personvern, vilkår og informasjonskapsler (cookies)   |   Organisasjonsnummer: 982 352 428 MVA