Sv: Dårlig varmeapparat?

[hma]

I think 'Nemsesk' have to answer about shipping (maybe a personal message will give faster feedback).

The requirement for installing the PTC air heater is gen2-pcu Think (VIN U005373 - ).

You will also need access to the latest hex-file and "C167 loader" for flashing PCU. That can be a problem for you in Switzerland.

The new Calix fluid heater will be much more easier to install, it simply replaces the MesDea fluid heater. However, in all cases you have to check that your heater fuses (inside the PCU) are not blown.

[stefan72]

Hello,
Thank you very much for the answer. The Calix fluid heater is also an interesting alternative. Thanks for the the tip!
Does anyone have a product sheet or article number? Does this heater need the same maintenance and regular venting as the MES-Dea heater or will it be more reliable?

[Go-carter]

The part number is somewhere here in the forum, i can see if i find it.

The calix hester is bulletproof. I get one in mine next week

[stefan72]

Hi Go-carter,
I am trying to get the Calix Heater in Switzerland. Not so easy! How do you get hold of it? Does the service station build it in for you or are you doing it yourself? Will the Calix heater need bleeding too? Any contact info where to get a Calix heater is much appreciated.
Best regards, Stefan

[Go-carter]

I will get my Calix heater in the next few weeks, as a warranty repair on the original heater. I havent experienced it yet, but i have seen it and it seems very sturdy. And the design is completely different than the original heater, much smaller and lighter.

[hma]

I am trying to get the Calix Heater in Switzerland. Not so easy! How do you get hold of it?

Which problems do you have?
I recommend you to ask Calix for correct installation procedure:
http://www.calix.se/en/contact-us
I'm pretty sure the Calix-heater also have to be bleed.

[Go-carter]

Here, you can find the part number as well as a image of the unit mounted in a Think:

http://www.elbil.no/elbiler/976-varmeapparat-for-think

http://www.calix.se/en/sustainable/product-range

[Kethorp]

Et spørsmål til dem med dybdekunnskap - etter en lang tur på over 10 mil på lørdag trengte jeg litt varme da jeg skjønte jeg ville komme hjem med god margin. Jeg skrur opp varmen, men null reaksjon kun kald luft! batterimåleren viser drøye 30% og jeg hadde kjørt E-modus siden jeg passerte 40%.  Dagen etter er bilen igjen fulladet og til min overraskelse virker varmeapparatet helt som det skal.
Er det slik det skal være eller er noe feil - hva er evt virkemåten?  PS, jeg har lyttet etter surkling eller susing, men hører kun viften til varmeapparatet.

[Nemsesk]

Heatern din er i ferd med å gå.... Da skrur den seg litt av og på.

Vi har fremdeles 3 x PTC er igjen 12000 med bytte og SW... Tror bare det er vi som har SW for å gjøre dette bytte, mulig noen har fått US SW fra Elkhart, men den skal ikke funke på EU biler.